Shelf with Display Pocket A1

To access or change prints are very easy, no unscrewing needed. Each pocket opens from the top to insert or replace prints and allows you to put 2 prints back to back one face inward one face outward if you are installing in the window.

1) Mark on the Ceiling where your fitting will be.
2) Measure according distance to second fitting and using LEVEL TOOL alight both for best straightness and mark the second mark.
3) Using a drill machine drill a hole where you marked your fittings to be, and then insert wall plugs. make sure wall plugs fully inserted and are flush with the wall.
4) Unscrew grub screw at the bottom of the support, support will split into 2 pieces. Brass part + chrome support.
5) Take small brass part and screw it into the wall with screw & plug. (repeat this for second fitting)
6) Slot in the support on to the brass part already screwed in to the wall. The brass part will completely go inside the support & hidden. Next, you tighten the side grub screw, so support will not come off from the brass part. ( repeat this for second fitting).
7) mark on the floor where fittings will be. Measure according distance to second fitting and using LEVEL TOOL alight both for best straightness and mark the second mark.
8) Unscrew bottom fitting so it would split in two. screw bottom part into the floor with screw and wall plug and tighten another part on it.
9)Lastly, attach Glass mirror with cable with the help of panel support. You need 4 supports per pocket and glass shelf with the help of glass support fittings.

Each kit comes with :
4 x 4M steel cable
2 sets of ceiling & floor fittings
Glass shelf 60x15Cm or 60x30cm
4 glass shelf supports
Acrylic Panel A1
4 Acrylic panel supports